FAQs

The manufacturing date is marked on the surface of the battery.

Recharge it after three months of storage, or immediately if the voltage falls below 12.8 V.

No. The battery must not be opened or dismantled.

No. Never add extra electrolyte to this battery.

Yes. The battery is supplied in an initial charged state and should be protected from short circuits during use.

No. It is specifically designed and recommended for motorcycle applications.

Crank the engine for 3–5 seconds and wait at least 15 seconds before trying again. Repeated failure requires battery and circuit inspection.

Disconnect the negative battery cable to reduce power loss caused by the vehicle’s electrical load.

Disconnect the negative terminal first when removing the battery. Connect the positive terminal first during installation.

Green indicates normal condition, dark indicates that charging is required, and persistent white indicates replacement is needed.

A voltage above 12.5 V indicates a normal charge. A reading between 11.5 V and 12.5 V indicates that recharging is required.

Constant-voltage charging is recommended. Always use charging parameters suitable for the battery model.

Maintain the electrolyte temperature between 15°C and 52°C during normal operation.

Store it fully charged, check the specific gravity monthly, and perform a refresh charge at least every three months.

Continue charging until the electrolyte’s specific gravity remains stable for three consecutive hourly readings.

Normally, add water after charging. If the plates are exposed, add enough water to cover them before charging.

Use only distilled, deionized, or approved purified water. Never use tap water.

Check it at least once a week, or more frequently under heavy use.

Yes. The electrolyte level should be checked regularly and topped up when necessary.

Yes. No water refilling is required, but regular inspection and cleaning are necessary.

Only trained and qualified personnel should inspect, charge, or service it.

Deep discharge can cause permanent sulfation, capacity loss, and reduced battery life.

Check the packaging, casing, terminals, and pallet for damage, cracks, or leakage.

No. Stop installation and report the damage to the carrier immediately.

Allow the battery to reach room temperature and use a compatible charger.

The minimum order quantity depends on the battery model, packaging requirements and customization needs. Please contact our sales team for an exact quotation.

Charging is complete when the voltage remains stable for three consecutive readings.

Keep the ambient temperature between 5°C and 40°C.

Stop charging immediately and allow the battery to cool before restarting.